To generate a radiation pattern based on measured data, choose "Generate Measured Pattern" from the "Study" menu in the main window.
The top part of the window defines the station configuration. This should be set to match the configuration for which the pattern is being calculated (generally this will be different from the 'reference transmitter' defined for the study).
Choose the dataset to use for calculation and click the "Compute Pattern" button. This will cause the output section of the window to appear. To generate the pattern, the program uses the "Ratio" defined for the selected dataset and the corresponding IDF, specified for that radial, to adjust the standard calculated pattern for the measurements.
The Measured to Calculated RMS ratio can be found at the bottom of the window. To generate a pattern plot showing both the standard and adjusted measured pattern, click the "Print Pattern Plot" button.
When printing, properties for the measured pattern can be configured by selecting the "Measured" tab of the printing options window:
